those of u with wilwood dyno's....

[Jamie.]

do me a favour and post the model no of the caliper please and all dimensions of bore size etc of the caliper will u please.

http://www.rallydesign.co.uk/catalog...oducts_id=8305

need to find the right ones to order on the above sight.... cheers

[matty]

If you search under a post called 4 pots the bore size of master cylinder is quoted on that

Can heck Haynes manual for disk width. Neeed to get from car.

[matty]

And have you sorted out brackets?

[matty]

Found post.

Bore size apparently: Posted: Tue Jan 03, 2006 11:23 pm Post subject:

--------------------------------------------------------------------------------

it's about 32mm size of piston measuring with ruler so i'd say the 31.8mm ones

[Jamie.]

And have you sorted out brackets?

yer im sorting it out at the mo

reckon with those wilwoods it'll be about 400 made up (prudent est, could come in at 350)

[matty]

Not sure why though but it does seem that midilite is only one available for the Bore size used (31.8mm)

£288.50 including pads so got to include brackets and hoses. Then cost of getting brackets made to fit car and caliper.

[Jamie.]

ill just give em a ring and ask for the caliper that fits a 259mm disc and 21mm thick. also richy is checking his for any finer details.... but i dont think there will be a problem of getting the dynolight callipers....

[matty]

But that is only half the story. Caliper is based on the master cylinder and this disc size so you can get them to fit the disc but guessing they may not work as well if you get caliper designed for larger master cylinder using a smaller master cylinder.....

I am sure someone will put me right if I am wrong.

[richy]

im going to measure mine to see what bore size is and the discs thickness spacing so he can try get correct set

[Jamie.]

they must have a reference chart for cars at h.o though, otherwise they would never sell anything