lowered the 16v yesterday, went a bit too far, and had to up it slightly lol!
Before:
After:
After again:
lowered the 16v yesterday, went a bit too far, and had to up it slightly lol!
Before:
After:
After again:
cool, never seen a white valver before. looks the nuts good job
That looks lovely.
1st attempt was certainly a bit low.
Looking good craig, can you send me a step by step guide on how to do it fella, please, as im gonna take mine up next weekend I think?
like it craig..mine needs doing big time lol
danny no probs, we made a guide when my mate first did mine on the nana!
http://homepage.ntlworld.com/brian.m...uide/guide.htm
how many spline do u need to go round?
what does 1 spline = __mm
2 splines= __mm
not sure mate, we just jacked it up how much we wanted to lower it by, then played around slightly untill the torsion bar went back in properly...