Engine parts for sale.

[MattL]

Hi,

been have problems with my engine for quite a long time so i have decided to break it up. after taking it apart its clear that cylinder one has gone a bit egg shaped causing it to smoke.

other then the cylinder, the rest of the bottom end is fine. its got APD Bolts and the oil pump has done about 200 miles. i will sell the bottom end with everything else that goes with it for - £20 pick up only

the head seems to be fine, it has been ported and 3 angle valves to be save i would send off to be checked before installing it - £100 pick up add £20 for delivery

P6230048.JPG

P6230052.JPG

P6230051.JPG

lightened and balanced Fly Wheel from Ktec costs £300 brand new. it has a bit of surface rust. £200 delivered

P6230053.JPG

P6230054.JPG

vernier pulleys and piper camshafts BP270. only done about 500 miles. £220 delivered

P6230055.JPG

P6230056.JPG

OMP straight through exhaust. warning very noisy. but sounds great. £120 pick up only

P6230059.JPG

williams manifold x2 £60 delivered.

P6230058.JPG

P6230057.JPG

rocker cover x3 one in blue £15 standard in good condition £25 standard in poor condition £10

Manifold inlet x2 £10 pick up only

head poor condition £10 pick up only


loads of other engine bits. so if you do come to pick anything up your more then welcome to look around.

im located at Portsmouth PO6

It might take me couple days to get back to you as i don't have access to the internet at home.

Thanks

[ThRaXaIR]

I have bought the Cams and pulleys. 23/06/12

[MattL]

cant get the images to work so im giving it another go

[mckoci]

Hello,
I would like to buy manifold + downipe .. is it possible to send it to the Czech rep. ?

[Mrbrightsi]

I'd of considered the exhuast, is it the mild steel one?

Shame you can't do delivery either.

[MattL]

mckoci pm'ed

i believe the exhaust is mild steel. at the moment i wont deliver the exhaust. if i don't get any interest in next few weeks for it. i will look into delivery after that

[Wobba]

That's a Williams Flywheel and head right?

What about the bottom end internals, pistons and rods? Are they standard Williams? And crank?

[MattL]

yes that's correct Williams Flywheel and head

all the bottom end internals seem fine.

[manxseven]

Hi Matt,

PM sent,

Cheers,

Simon

[-jo-]

just a question about the flywheel Matt, i cant see it in the picture but is the whole pattern (flywheel sensor, pick up) machined ?