Parts list for full ITB set up - Williams engine

[Evogone]

What is the total list of parts needed for a full ITB set up:-

Including which flywheel and clutch and short rad etc.

[Laine_16v]

From the top of my head....

Manifold
Throttle Bodies
Throttle linkage kit
Air horns
Airbox backplate
Air filter

3m of Fuel hosing
Fuel Rail
Fuel pressure regulator
4 x Hi Impedance injecotrs
4 x Injector blanking plugs

Throttle position sensor
Optional Air temp sensor

Meganne Flywheel & Clutch
Low Profile Rad & Fan

AFtermarket management with distributer'less setup

Lots of nuts and bolts to put it all together.

Im sure thats most of it but no doubt forgotten someting.

[Evogone]

Do you get new sensors too ? TPS / Coolant temp etc..?

[AndyFielder]

new TPS but the rest just use what is on the engine

[sideways danny]

dont need a rail or any hose. Use injectors in stock position.

Whatever ECU you get you'll need a megane/172 flywheel and clutch. New ECU should come with, or have available a TPS, air temp sensor and coolant temp sensor.

[sideways danny]

on and you dont need a regulator either, as if you use the stock rail in stock position, you can keep the stock regulator

[sideways danny]

Injectors!!!! you'll need high impedance ones most of the time with aftermarket management, so megane injectors are an easy solution

[Coops]

Injectors!!!! you'll need high impedance ones most of the time with aftermarket management, so megane injectors are an easy solution

your not @GDI

[sideways danny]

I know. Been trying to get hold of one of the admin for about 6 weeks now

[Coops]

par for the course

NNNOOOOOORRRRRRTHHHRRRROOOOOOOPPPPPPP, where are you boyo