omex or crank sensor problems

[valver_Karl]

iv got a itb clio. and iv recently changed the gear box, iv put everythin back together but the car wont start lol. there is power goin to the omex, and the starter motor cranks over, but the plugs arnt sparking,

any1 got any ideas? if nt will be goin to gdi,

[J o n]

Karl, I'd give Andy Cutler or Richard Wragg a call mate, they will be able to help you over the phone I'd imagine.

[stan]

Have you got communications with the ecu?

You really need to see if its recieving a cranking signal.

[valver_Karl]

Karl, I'd give Andy Cutler or Richard Wragg a call mate, they will be able to help you over the phone I'd imagine.

yea spoke to andy, he had trouble gettin the starter codes for the omex in the 1st place, but i would have thought they would have been saved like a hard-drive, that is wot i think the problem is, "omex".

andy gave me a few sugestions, which i have tried but still no power. think i need a little lift from the rac guys ;)

an stan i got no idea how to check that?

[stan]

Have you got the Omex software and a coms lead?

[valver_Karl]

na m8, dont even have a laptop.

[Wobba]

Did you replace the earth on the gearbox

Might be something simple. Flat battery?

[stan]

Its cranking over, so presumably battery and earths are fine..

[valver_Karl]

ye re-charged the battery, and yup all earths ar on, its a mystery

[Wobba]

Didnt see the cranking bit lol.

Are there any batteries for storing the settings on the omex when it's unplugged or has no battery power? If it has and the onboard battery has run flat it could have lost the settings as previously mentioned.

See if you can borrow a laptop, install the management software and have a look that way.