im gna be travelling up on sat morn early, wot time do the gates open?
is anyone from or near kent going? its gna be the first time i do the strip(if my motor is running) any one gt any tips or is it jus my launch? at wot rpm?
im gna be travelling up on sat morn early, wot time do the gates open?
is anyone from or near kent going? its gna be the first time i do the strip(if my motor is running) any one gt any tips or is it jus my launch? at wot rpm?
Hi there not sure on opening times but
Regarding launch i had Willy 1 and a santa pod i ran 15.9 after a few attempts which still wasnt brillant but i found the best revs is somewhere between 4 & 4.5k as long as you have uprated clutch or newish clutch side step the pedal and keep the gas pinned if it hits redline after jumping hold it as 9 times out of ten it will be the wheels spinning you will know when your near the pin, try and judge it with speed aswell as revs will get a better entry in to second without dropping to many revs then the rest is well crossing the line with out hitting redline in third and fourth
:D Good luck
4kish on cam, ease off a lil if wheels get bogged down and back on as soon as, change just before the limiter, take your spare, sub etc and rear seats out :D
gna strip it rite out? the missus can sit on floor for 2 and half hour trip! wot sort of time should i look for, standard apart from stainless with decat and a shite k&n, 15's lowered 50mm?
in that case loose the sound deadening from under the carpets as well it weights loads, **** it loose the carpets
theres a site that calculates qm etc hold on...
Stadard willy with full system (decat)
should see just under the 16's depending age, clutch, launch etc etc etc
Mine did 14.9 with Decat and MagnexOriginally Posted by David
Think if you launch at 4-5k and side step the clutch you'll get 16s! I launch at 2-2.4k and feed the clutch out and power in slowly...got 14.97 in stripped williams with filter, zorst and chip on 1st ever go.Originally Posted by David