loom missing a couple of plugs

[teabag]

right, been wiring up my valver rt todayand came across a few wires without plugs on...im 90% sure what there for and have spare plugs to attach but id like some confermation

soooo here goes.

1. three wires coming out of the loom at the back of the block near the starter motor, im sure these are for the lambda sensor, theres a white one, a black one and a yellow one



2. two wires coming out of the loom near the top engine mount, theres a cream coloured one and a white one, i think these plug into the radiator but they have been cut back short.



and where i think they go...


and finally

3. a red and a black wire coming out of the loom at the front of the engine (underneath the inlet mani not above it) i have no idea what these are for.



there you go. what you think???

[teabag]

also any idea what this is for and do i still need it as there isnt a plug/wires for it in the valver loom



(sorry about pic size/quality)

[MAXIBOY]

1 i agree lambda sensor.
2 wires for the switch which runs the fan for cooling. connect together fan should run.
3. not sure. under the manifold theres a knock sensor and a cold start injector. check these.

think the final one is to do with the recirculation system. mines mounted in a different place though...

[teabag]

right, thats confermed 1. and 2. for me (aswell as looking at the wiring diagrams in haynes)

ill have a poke around to see if theres anywhere for 3. to go

any more ideas about the other pic??

cheers maxi

[MAXIBOY]

i,m sure its some sort of air inlet valve in the cannister system that runs from the rocker cover.