Should I Go Valver Track Spec?????

[skipp123]

hi guys iv been floating around on this board for a couple of years now and stupidly brought a vts over a williams a few years back, i now drive a 400bhp mr2 turbo rev4 which is my weekend drive and have a trusty metro 1.1 for daily comute which im sooooooo bored of now and looking for something relaible with good build quality fairly nippy and something that has the potential to be a a-b rd terrorist oh and fairly cheep to run {dont want alot hey lol} now iv shortlisted the cars into the below

clio valver
metro 1.8 vvc
mini 1295gt {clasic}
pug 205 gti {1.6 or 1.9}

all the above would have minamal engine mods and just ALOT of suspension work ie coilovers, anti roll bars, polly bushs the whole shabang and a nice set of small rims i have a budget of around £1300 for the car and oviously a bit more for mods, if it were your money what would you go for?

id love a valver with
k&n filter
full exhaust
chip
all suspension work done
full roll cage
harnesses
stripped out
and some ronal turbo wide wheels on a graphite colour car {u can see what im after from the above}

[Zollo]

Valver will be the best day-to-day proposition, followed by the 205. Personally (and this is just a personal thing!) I wouldn't even consider the other two, for various reasons.

Valver gets my vote

[nyk]

valver or the 205 - only the 1.9 though.

:D

[skipp123]

just a taster of my weekend toy



and a idea of where id take the valver suspension wise the below set up is currently on my mr2 tubby

Cusco front strut brace
Cusco Rear strut brace
Tein Flex coliovers
Front lower tension rod linking brace
JIC magic lower arm brace
TRD antiroll bars
TOMS pillowball tension rods {FRONT}
TOMS pillowball tension rods {REAR}
Urethene suspension bush kit
Urethene engine and gearbox mounts

[northy]

valver is my vote aswell...

Nice to hear from you again buddy.

[skipp123]

hey northy nice to hear from you mate, remember the king stromba days that guy used to make me laugh lol, good to see your still floating about bud....

[northy]

So do you not fancy the williams youve always wanted - this one is cheap !

http://cgi.ebay.co.uk/1994-RENAULT-C...QQcmdZViewItem

[skipp123]

thats not bad mate but looking for a valvre for slightly cheeper insurance and the fact i could leave it places without worrie, id be to parra about having a williams as a every day car,

was basicly looking for a cheep mechanicly sound valver so i could just fine tune the suspension and a set of ronal turbo alloys and be done, wouldnt wanna spoil the williams bud

full suspension set up
new wheels and toyo r888 tyres
straight through exhaust
filter
stripped
carbon seats
= job done

[Clio_GTT]

bang the williams setup on a valver ;)

[MAXIBOY]

carbon seats for sale here

http://www.williamsclio.co.uk/forum/...ic.php?t=21753