Cold Air Feed - Off Side !!!

[Piper]

I'm looking to run a cold air feed to by air box from the near side blanking plate. Easy to do!

But I was also thinking of running a second feed from the off side blanking plate. As any one tryed this ?

The route looks a little tight running under the inlet manifold, between the engine and the rad. But I thought it would be a good idea to increase air flow and also balnace up the look on the bumper with two ducts rather than one.

Any thoughts

[Mr.AdamB]

tbh i dont think it will work anty better, if anything it will disrupt the other flow. best to have 1 decent air feed IMO