Hub to strut issues

[donsrno1]

When I was replacing the gearbox on my 16v over the past weeks or so (not had a chance to work on it properly) I noticed that theres something a bit strange when connecting the hub to the strut on the passenget side.

On my other clio you just have to push the hub back a little and it lined up with the holes on the strut so it was easy to do up, they were at the same height in the first place. However on the 16v passenger side I have found that the hub bolts sit much higher than the strut bolts (by about 1 - 2cm roughly) and to get them lined up you really need to push down on the wishbone arm to get them lined up. When doing it the only way I could manage it was by putting a screwdriver in the top hole and levering it down so that the bottom would line up.

Any ideas on what could cause this, and should I be worried by it?

[Justin..]

nah thats ok nmate, its just the ARB pushing it up

[MatBrown]

As he said, just the ARB.



Mat.

[Lunner]

Normal

Pain in the **** arse to line up tho lol, esp pushing down with one hald and 'jiggling' (techie term there) the bolt about

[Coops]

its easy get a mcpikie on a bar and set him jumpin! :P

[McPikie]

its easy get a mcpikie on a bar and set him jumpin! :P

Just watch his legs shaking because he is still hungover and hasn't eaten for 12 hours