View Full Version : 1.8/2.0 inlet manifold
Swervin_Mervin
21-03-2005, 18:08
Is one significantly bigger than the other?
Noticed on JB's Willy 1 that there seemed to be some eoom between his manifold and the cross member, but fark all on my valver.
Think there the same?
My willy 3 and valver one were the same
the williams manifold and the 16v 1.8 are exactly the same - no difference at all
Swervin_Mervin
21-03-2005, 18:16
So why the hell does my dipstick almost touch the cross member and yet the one in JB's willy 1 is probably 1-2inches fron the cross member?
Does the head sit further forward or summat?
because 2live has a megane bottom end, so the dip stick is in abit of a different place.
i would say it's to do with the crash perhaps Mike?
Swervin_Mervin
21-03-2005, 18:21
Soz, not 2Live. Johnny Brown aka Irish Nut.
oppps....
Your dipstick tube could be bent forward?
Swervin_Mervin
21-03-2005, 18:26
It's not just the dipstack though. The whole lot just seems closer to the x-member. :?
VIPERONE
21-03-2005, 23:52
irish nut has had a bump iirc
Swervin_Mervin
22-03-2005, 11:07
If you check THIS (http://forum.cliosport.net/display_topic_threads.asp?ForumID=13&TopicID=149119&PagePosition=1&ThreadPage=1) thread on CS you can see what I mean. Irish Nuts is like Wonstons and Rhino16vs. You can get you hand between the manifold and cross member.
Mine is like _simon_'s in that you can't!
Any reason do you reckon?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.