View Full Version : Using a damaged head for gasflowing?
Assuming i want to get a head to be gasflowed it is safe to buy one from an engine where it has suffered a cambelt snap and has bent valves?
i.e. i take it is unlikely to have any damage to the casting and the damaged components will be cheap to replace?
Opinions/Thoughts appreciated!
Thanks
yeah will be fine. get it skimmed aswell.
just make sure the combustion chamber isnt pitted/damaged due to launched valves!
Ah, that sounds hopefuly then!
BenR over on CS reckon that there could be the possibilty of damage to the valve seats but i guess i should be ok as it's not a high performance engine (1.2)...however, apparently ALL valves are bent. Will these cost much to replace do you think?
Slithers
04-03-2005, 20:36
the valves are about a fiver each from GSF car parts IIRC
Slithers
04-03-2005, 20:37
well the valver ones are so i cant see the 1.2's bein much more expensive
just check there is no damage to seats/chamber. does a 1.4 energy not have bigger valves? worth looking at one of those heads if it will fit
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.