View Full Version : Chip for use with cams
Brealbags
17-08-2010, 23:37
I'm after a decent chip for a 2.0 with breathing mods and piper270's.
Iv tried looking for summeh's old thread but unsure wether they are still available
Chris
He does not do them anymore as far as I know.
You could try getting a Gunnerchip F7R Cams chip. It's setup for your spec roughly. I had one but I think I gave it to Summeh ages ago.
I tested it on non cammed F7R and it gave it a rough as fook idle :p
best off gettin a map to suit the mods/engine mate. will cost more but will be far better in the long run.
Brealbags
18-08-2010, 12:40
I know but i need something to run the car while I run the engine in. Then after 1000miles or so I can take it for a proper map
MatBrown
18-08-2010, 16:46
Try Midge.
Mat.
i use a normal gunnerchip in mine with 270's, it gives good afr (using my lumintion afr meter £100 not a cheap shit gauge) and the car pulls great! i was going to get a re-map but it runs spot on as is!
Brealbags
18-08-2010, 19:01
I might try it with the 180 i have then. Maybe i can borrow a gauge and test the AFR
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.