PDA

View Full Version : Front bumper captive nuts


snowman
13-06-2010, 08:41
All 4 in good condition please as mine are mullered :roll:

thanks
snowman
14-06-2010, 12:52
bump
Wobba
14-06-2010, 14:28
You mean the side ones with the nut sleeve/peg and the two on the flaps underneath at the front?
snowman
14-06-2010, 16:02
yes mate,the 4 main holding nuts and bolts,cant refit the bumper untili get some :(

Anyone know the Dialogies number if nobody got any please?
snowman
15-06-2010, 08:02
bump
snowman
16-06-2010, 07:32
bump

:(
snowman
17-06-2010, 06:21
anyone :cry:
Wobba
17-06-2010, 13:02
I have one :( Not all.

Tbh mate the only reason I have one is coz I swapped the right hand side one that goes through bumper and wind and shell with an M8 nut and bolt as the one I have was not gripping enough.

I am sure beakers will have them or you can make up some alternatives!
snowman
17-06-2010, 13:35
Are there alternatives? Wont be able to refit the bumper until i sort something out.
Wobba
17-06-2010, 14:17
Well, you got the one under the bumper, thats just a nut.

The two underneath I had to grind off as they were seized totally. Could easily drill them out and put different ones in through the plastic lapel bits.

The ones to the side can be replaced with a bolt or something. I think mine was M8, just slotted it in so the thread came out the other side near the horn and bolted it in, job done.
snowman
17-06-2010, 14:45
hmm,will investimigate this later,ta