View Full Version : cat cam 301
paudi294
10-09-2009, 19:44
any 1 had any dealing with these cams. what are they like. whats needed for them to b fitted
with apd head work
lightened balanced b/e
high comp pistons
cheers
volymmannen
10-09-2009, 20:16
◄
5502301
REQUIRED PARTS
followers: CC002
retainers: 99337
springs: PAC-D92009
paudi294
10-09-2009, 20:47
are thay any good and will thay run with my mods??
any idea of price?
paudi294
10-09-2009, 21:07
cant seem to find the pac-d29002. cant see them listed
volymmannen
10-09-2009, 21:55
I am sure that the spring are available anyway.
i think the the required parts is quite expensive perhaps almost as much as the cams.
What power are u after, were will you drive the car ??
will need quite a bit of work done i would of thought because of the massive valve lift, also probably need tb's to see the best from them. is it a road car ?
paudi294
11-09-2009, 18:16
any thing over 200bhp im after. and will b on the road.
ITBs will be being fitted as well
also what cams would any 1 recomend then with the mods
cheers
volymmannen
11-09-2009, 20:21
any thing over 200bhp im after. and will b on the road.
ITBs will be being fitted as well
also what cams would any 1 recomend then with the mods
cheers
200 from a 1,8 ok
for road use on those cams, i would recommend 5502213 if you go for road use..
paudi294
11-09-2009, 21:41
2.0litre.
cheers 4 the advise.
volymmannen
11-09-2009, 22:52
2.0litre.
cheers 4 the advise.
ok ...
Laine_16v
24-09-2009, 17:09
To run those cams, you will need Catcam GOLD springs and retainers and Shimmed mechanical lifters. That little lots will probably set you back about £600.
I run the cams just below that the 2320's, and can get away with using hydraulic lifters.
I run the cams just below that the 2320's, and can get away with using hydraulic lifters.
Although Cat cams state solid lifters for these cams...... :wink:
To run those cams, you will need Catcam GOLD springs and retainers and Shimmed mechanical lifters. That little lots will probably set you back about £600.
I run the cams just below that the 2320's, and can get away with using hydraulic lifters.
And the rest---catcams solids alone are £450+vat. Springs and retainers are a bit less again.
sideways danny
28-09-2009, 11:36
I'd go for 213s and stick with std valve gear :)
Laine_16v
30-09-2009, 21:26
Wowser didnt realise solids were quite that much!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.