MOT Coming Up Need Bits!

[Jesse16v]

16v Catalytic Converter
16v Bonnet (Preferably in 449)
16v Air box (with good filter preferably)
16v 449 ph2 grille & light clips
Rubbers & Bolts To Hold Radiator To Cross Member
Powerflex Dog-Bone Bushes (Where can i get these apart from ktec?)
Rear Discs (Cheapest place to get these?)
Hand Brake needs tightening up, is this hard?
Aerial

also is there anything else i should check for MOT

[stevie_b]

Hand Brake needs tightening up, is this hard?


Nope, it's pretty easy. There are a couple of 13mm nuts that go onto a bolt that goes through the cable holder that both handbrake cables go into, underneath the car below the handbrake. Tighten that up and it should do the trick - if not then the cables have probably stretched and you will need to fit new ones.

[Jamie.]

May be best to borrow a local member's cat as they are dear to buy as they scrap for so much.

[tony16v]

i've got a 16v cat it on ebay at the mo....

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=120318128994&_trksid=p3907.m32&_trkparms=tab%3DSelling

I got a bonnet, grill (but no clips), rubber and bolts to hold rad, good condition rear discs, aerial... etc

[Jesse16v]

Need a radiator & fan now too!

[tony16v]

I got a rad and fan too...

drop me a PM if your interested..

cheers Tony.

[andreas395]

i've got a 16v cat it on ebay at the mo....

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=120318128994&_trksid=p3907.m32&_trkparms=tab%3DSelling

I got a bonnet, grill (but no clips), rubber and bolts to hold rad, good condition rear discs, aerial... etc

will the cat be ok for a williams