View Full Version : manifold studs
can you get a manifold stud which is m10 course on one end and m10 fine on the other.
with the fine thread the longer end...
Not sure, but you could always use a die and make your own
It depends on the material you want them in but you should be able to get hold of them even if you have to have them custom turned.
If you're only after them in mild steel (grade 8.8 - 10.9) with say M10x1.5/M10x1.25 then it's a pretty easy job and won't cost the earth. What legths do you need cos I can ask for you at the place that made my rear beam bolts?
Mick
cheers mate.
they need to be 10mm x 1.5 for 10mm 10mm shoulder then 10mm x 1.25 for 15mm ideally
someone has suggested cosworth studs so will try burton on wednesday.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.