View Full Version : brake bias question (fao track users)
right all you track goers, are you using the standard rear brake bias valve, or have you fit an aftermarket in-car adjuster?
those of you that are using the standard unit and have lowered cars, do you have any problems with the amount of bias put to the rear, or even the rears locking up?
thankin you :D
u can adjust the std one.
u can adjust the std one.
do go on :)
BristolSam16v
17-12-2007, 15:24
There u go
http://www.retro-renault.com/forums/engine-mechanical/46-rear-brake-bias-valve.html
stevie_b
18-12-2007, 10:18
If you want to adjust the bias in car then you'll need to reroute the rear pipes through the car and fit a proportioning valve.
http://i83.photobucket.com/albums/j299/2stis/clioproj6.jpg
how would u go about properly setting the bias up?
stevie_b
18-12-2007, 11:43
With the adjuster like in the pic? You just turn the knob depending whether you want more or less braking force going to the rear. If it locks up the rear too easily in a certain situation (wet track, poor surface, etc.) then you just wind off a bit each time until you are happy with the balance. Doing the same on a converted original bias adjuster under the car isn't quite as easy as the set up method per trackis pretty much trial and error and you'd need to come into the pits every lap to adjust and retry!
well aye. u adjust it til the rears stop locking up under braking....or until your happy with how it feels.
If you want to adjust the bias in car then you'll need to reroute the rear pipes through the car and fit a proportioning valve.
http://i83.photobucket.com/albums/j299/2stis/clioproj6.jpg
It's very good for racing use but not for street use (IMO). Don't forget the standard Williams / 16V brake bias valve is load pendant and adjustable!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.