View Full Version : Clutch Plate
Looks a bit 'marked' to me, not grooved to the touch, but straited with dark stains and a few 'sploges'
this isnt a problem is it? can they be refaced aswell as its an uprated plate and not really wanting to fork out for a new one!
http://i14.photobucket.com/albums/a330/coopahstar/PA300022.jpg
http://i14.photobucket.com/albums/a330/coopahstar/PA300021.jpg
and advice much appreciated
cheers
Coops
looks fine to me mate
http://img91.imageshack.us/img91/5818/img4056kr2.jpg
thats the one off my low milage megane lump, yours if you want it.
cheers for the offer matey, but i need to keep this one i got as its an uprated item for the turbo goodness! 8)
lewis_willy2
01-11-2007, 17:49
does it have to be an uprated 1? i got a standard williams item with standard release bearing???
lewis
mike16valver
01-11-2007, 17:53
does it have to be an uprated 1? i got a standard williams item with standard release bearing???
lewis
If your making a tubby,
I rekon your friction plate will have a hard time trying to keep a grip when the Turbo kicks in...
Coops, looks like its taken some heat. id get a newer one to be safe.
tis an uprated one lewis mate, sure std one wud slip like fook, altho dont know?
its got a couple of heat spots on it, but theres no warping or anything or grooves or anything so i'm going to use it i think, cant afford a new one anyway at the min, if it slips i'll take it off when i can afford new un!lol
Crossers
01-11-2007, 19:35
It'll be fine lol
You chaps worry too much!! Its just been a little scorched, it'll be reet when you use it again.
You should see the scorch marks on my crank!!
Paul
lewis_willy2
01-11-2007, 19:53
great, was collecting my flywheel 2mro ready to put my engine in on saturday. what is uprated about it?
It'll be fine lol
You chaps worry too much!! Its just been a little scorched, it'll be reet when you use it again.
You should see the scorch marks on my crank!!
Paul
its not worrying too much mate, its just trying to make sure the car not only runs but is reliable after each job i do. so i look into all options as i havent got the time or patience to rip it apart quickly as i have too much to do as it is :wink:
great, was collecting my flywheel 2mro ready to put my engine in on saturday. what is uprated about it?
think it has a stronger set of springs so increases the clamping pressure on the clutch plate. thats why they feel heavier under foot
mike16valver
03-11-2007, 12:58
They also with stand high temperatures :D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.