View Full Version : 5mm pin punch
Im after one of these to remove a driveshaft, but can't find anywhere that sells em!
anyone got any recommendations?
stevie_b
12-06-2007, 14:20
I used an old 5mm drill bit as the punch. Tapped the end with a hammer, not using it to drill it out!
thats looking to be my option now as well
just hope its strong enough, as I might have wedged a bradle in there :oops:
lukebartlett2405
12-06-2007, 16:02
you can use anything as long as you take the point off it or the pin spreads in place and is harder to get out i used an old nail just took the point off
Ebay and screwfix sell them
Usefull tool to have a set of punches.
think ive fooked it up now
wont budge at all
cant even drill it out!! :shock:
Bailey_1260
12-06-2007, 18:56
Tyr t from the other side.
Will need a good slap.
Mine disintergrated :P
BristolSam16v
12-06-2007, 21:00
Any decent motor factor will sell a set of punches!
AndyFielder
12-06-2007, 23:11
GSF sell sets mate!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.