View Full Version : Valver block needed
Hey I'm after a good Valve block with the original main caps ideally in the Midlands or a Megane bottom end :)
I think I have one...will Pm you monday
cheers Stan appreciated :D
jwarren2k2
05-03-2007, 00:15
pm'd!
James
i have one - recent reconditioned unit as its stamped on the back.
Complete engine - will need gasket and cambelt replacing as i removed the head to remove from car.
Based at wigan
What block is it and how much do you want for it. Is it the complete botttom end :D
the engine is complete bar the cambelt, exhaust manifold and a head gasket. Even has a half worn clutch on.
The bottom end looks very new and the outside is very clean. The inlet manifold is from a R19.
Will get pictures if i need to ?
So its a Valver engine. Just want the block really.
Basically bought a R19 engine from a breakers that was a pile of sh**e with bent rods and small cracks on the surface of the block that i couldn't see until i stripped it down.
Then bought a block from miles away which once i got down there found there were no main caps. Tried the ones that i had at home yet no good!
So now i'm after a decent block - third time lucky :D
If you,ve got some pics of just the block great. How many miles it done and how much you want for it?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.