View Full Version : Cam belt
Anyone know what happens if you are slightly out on the cambelt, reading the haynes it says your idle will be wrong, obviosuly not massively out as it would damage stuff, but say 1 or 2 teeth out either way....
how much can you be out and would it idle higher or less?
depends my mates golf was out and it just lacked any sort of power
You did it yourself didn't you?
yeah, it drives fine, but either i have knocked a vacume hose or cam belt is out :/
It idles at 1500 on start up then after a blast it goes back to 900 then slowly goes back to 1500 over time, when i say blast i mean getting it to the limiter foot to the floor then letting it idle .
I checked the belt though and when i cranked it over TDC came back around and all the marks lined up (red dots), how ever after cranking it over the white lines on the belt were out
MatBrown
30-12-2006, 16:52
how ever after cranking it over the white lines on the belt were out
Yeah, it would take a lot of rotations to get the markings on the belt to line up with the pulleys again.
Mat.
As above, i'd say its a sensor/vacumn hose you've knocked, ahve a look at the idle problems in the guides section
Cambelt being off wont' give those symptoms, and if it lined back up when you checked it then it will be fine, as mat says it takes alot of rotations for the marks to line up again
ta guys will check it out new years day i suppose :S
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.