FincH
03-11-2006, 10:51
Hi.
I'm going to try replacing the gearbox/battery tray engine mount on the Valver today but am just curious as to if it's a simple swap over job or does it need to be aligned correctly and torqued up? I dont have a torque wrench btw :)
Also is the mount the same on all the models? Not an uprated one for the 1.8 or anything?
Also I might need to remove the lower downpipe heatshield. Is this hard?
Because basicaly that heatshield is touching a pipe on the PAS rack and making a noise so something needs doing.
Cheers.
I'm going to try replacing the gearbox/battery tray engine mount on the Valver today but am just curious as to if it's a simple swap over job or does it need to be aligned correctly and torqued up? I dont have a torque wrench btw :)
Also is the mount the same on all the models? Not an uprated one for the 1.8 or anything?
Also I might need to remove the lower downpipe heatshield. Is this hard?
Because basicaly that heatshield is touching a pipe on the PAS rack and making a noise so something needs doing.
Cheers.