Hi all,
The subframe on my Williams 3 is bent to the point where it's not viable to repair. This means I need to get one. I really haven't been able to find a Williams subframe, yet, and trust me, I've searched for hours and hours. However, there seem to be quite a few Valver ones, which aren't as strong as the Williams ones. How bad, exactly, would it be to use a Valver subframe on a Williams?
Can a Valver subframe be reinforced to be just as strong as a Williams? Perhaps some material from the old subframe could be used and welded into the new one?
There is a local shop that could 3D scan my old one, replicate the good side into the bad one, and manufacture one, but that will cost way too much money.
Thanks,
Bruno