HELP!!! Car won't start!

[northy]

Have you checked the distributor cap and rotor arm?

What condition is your ECU in?

[waynos83]

Have you checked the distributor cap and rotor arm?

What condition is your ECU in?

Hi Northy, We have replaced the dizzy cap and rotor arm for new parts. I have no idea what the condition is like. I will get my mate to have a look. Could a wet/damaged Ecu produce the problems I'm getting?

Thanks

Wayne

[waynos83]

Hey everyone! The willy has finally risen from the dead. After changing a load of parts and being a month off the road, it turned out to be a break in the wiring loom. It was rubbing against the bodywork and cut through a few wires!
Thanks to everyone who spent the time to post a reply on here.
All the best
Wayne 👍😉

[northy]

what part of the loom was it?

Just in case someone else is having the same issue.

[waynos83]

what part of the loom was it?

Just in case someone else is having the same issue.

I think it was on the drivers side near the headlight and was rubbing against the bodywork. I will get a picture up to show exactly where it was! 👍

[waynos83]

what part of the loom was it?

Just in case someone else is having the same issue.

Right guys, here the culprit for all my non-starting problems. The wiring loom on the passenger side, low down near the headlight. Over time it rubbed against the body work and broke through. Thanks again for everyone's help.