where did you get the rear 1/4's from and how much were they?
where did you get the rear 1/4's from and how much were they?
Carbodypanels.co.uk mate. Wings are 29.97 for os and 25.76 for ns...
I ordered all these for a total of 210.86 delivered to my door the following day
They are brilliant quality too. Almost as good as Genuine Renault imo
Carbodypanels.co.uk mate. Wings are 29.97 for os and 25.76 for ns...
I ordered all these for a total of 210.86 delivered to my door the following day
They are brilliant quality too. Almost as good as Genuine Renault imo
so your idea is to use a non 16V wing and flair it out my fitting onto the standard 16v crease line?
Yes mate. I've worked in body shops so I'm pretty good with a set of panel beating tools... I'm using the full "up to window" rear quarter and modifying it to flare as a 16v/williams would.
There's a trick to it which I will post on when I come to the other side. I used this method on a mates rt clio and people thought it was a valver shell so can't have been a bad job lol 😝
Been doing a bit of work on the car today, managed to remove the front panel and test fit the new one. Was going to sandblast the engine bay too but I'm going to leave it until I get a sealed gazebo 😉
This came in handy for getting rid of the seam sealer in the hard to reach areas
Removed the subframe and all attached bits
Brake hose nut was dead tight, so had to snip the tw@ lol
Salvaged an old mop stick to retain some stiffness lol
Always wondered why my scuttle would fill with water haha
that's one way to gain access from underneath with a sander lol
a rust patch was found, gauged up
A bit of the old quarter panel is the same gague waste not want not lol
marked ready for cutting out (line is shabby, I'll cut it straight and weld it better lol)
removed old front panel (forgot I'd not tacked the bar in place lol!
new front panel offered up to the car ( still need to cut some out for the removable slam panel )
that's it for today I'm afraid. My front inner wings should be here this week, so will be able to progress a bit more then. Also decided I'm buying new tools as some have been "borrowed" fml... Lol