ive not fitted this yet, but i want to go on holiday this year really badly and my funds are very limited now im paying a lot more insurance due to the crash of the Clio GTT
this CDA is the same size as the one for the 172/182, its wide and short, however it has the 85mm engine side opening, not the usual 70mm one, with a hill power bend in place you should be able to use a drop down adapter and fit this to a 172/182?
i sourced a good inlet adapter which looks like this, its tapered so should give better flow than the K-Tec one, its also larger
I then bought 2 breather filters and pipe connectors, and some silicone hose, oh and of course the BMC CDA
the costs were as follows
adapter - £25
CDA - £200
breathers - £8 each
pipe adapters - £3 each
total cost is £247 not including the silicone hose, the reason ive not included that in it is that this doesnt fit in the space available if its wanted to be pointed forward, some wire reinforced ducting hose from SFS/Samco would bend perfectly to do this and keep diameter but i never got around to buying any, ive used it before and it definitely would fit very well
if this doesnt sell then when ive got some cash available its getting fitted properly with some of that hose, but at the moment my funds are very limited and i cant really afford to have this sat in my room doing nothing
this is how it could be setup but personally i wouldnt use a silicone hose id use wire reinforced flexi ducting as it would fit easier
this is it fitted to my car, however the engine wasnt run and nothing has been done up tight, i was just checking for room etc, i didnt have the breather hoses at that point
im open to offers on the kit, no i wont take less than £150, ideally id like £200 for it but i know most wont pay that even though everything is brand new
post any offers or pm me, its up to you