Hill power chip or just a rolling road?

[Winston]

Im thinking of get my car hill power chipped

But is it really worth it, revs to 6800 anyway. might just get it rolling roaded and checked over by nick and not bother with the chip.

How much is the rev limit increase Martin?

not planning on getting cams.......would it be worth getting a remap else where?

Current mods...ITG filter, P/S pump removed, Decat and Scorpion

What should I do?

[big hp]

Personally i'd leave it at 6800. Whats 200 or even 400 revs if it makes good power????? I could understand it if like martins it only revs to 6400. Just my opinion though.

[Winston]

Well thats what I was thinking, 6800rpms not that bad.

Just want to make it go faster

[Rich]

either that or save the extra up for a fully mappable management system like omex or something then you can always have it mapped accordingly no matter what you change on the engine! whereas hillpower chips etc are encrypted

[richy]

u thought about a manifold? will help with rev limit raised abit, other then that i dont see point tbh if u not getting cams leave it as it is will be fine

[Martin]

Im thinking of get my car hill power chipped

But is it really worth it, revs to 6800 anyway. might just get it rolling roaded and checked over by nick and not bother with the chip.

How much is the rev limit increase Martin?

not planning on getting cams.......would it be worth getting a remap else where?

Current mods...ITG filter, P/S pump removed, Decat and Scorpion

What should I do?

Chip copied from smt6 and rev limit upped is 150 or less depending on payment method...which is pretty cheap imo. Like richy says I'd consider a manifold and full remap...should get you a few horses and some torque. How come yours and jesus' revs to 6800??

[northy]

mine can get to 6800 if fully warmed up.

Its weird. At just under normally opperating temp its 6500 then as soon as its gets above it varies upto 6800

Im not complaining..heehee

[2 live]

mine was the same.sometimes it revved higher...still does it now.limits at 7100 but sometimes more like 7500

[ballcrusher]

mine revs to 7800 rpm and loves it just ask winston he was SHOCKED

[Winston]