Setting rear axle ride height

[lkcio86]

Been battling with the other halfs williams tonight as it was lowered ridiculously, got torsion bars out dropped shockers off etc but no matter how hard i try i cannot get the vehicle to sit level side to side, although both sides have been highered, i have a difference of around 12mm, any ideas anyone? i did the same procedure in my old valver and all went well

[A&P]

You can adjust ride height in smaller increments on the anti roll bar ,it may have been lowered that way which is giving you different heights either side

[lkcio86]

This sounds interesting how do i proceed, never heard of doing it that way

[A&P]

You have p.m

[pvsmark]

Care to share the info because mine is the same?

[volymmannen]

if you have the car level and push the rods in at that position it cant be wrong, but the exact way is to measure the length between the damper holes, and when its exact, push the bars in.