Results 1 to 10 of 10

Thread: Heaters

  1. #1
    Forum User redeye83's Avatar
    Join Date
    Dec 2008
    Location
    worcester
    Posts
    294

    Heaters

    Hi all my heaters are pretty shit as hardly produce any hot air. What is the best place to start for fixing it, is it the blower motor?

  2. #2
    Forum User
    Join Date
    Jan 2007
    Location
    Wilts
    Posts
    274
    If the fan still works then id probably say heater matrix - used to have these go all the time

  3. #3
    Forum User redeye83's Avatar
    Join Date
    Dec 2008
    Location
    worcester
    Posts
    294
    Where abouts is it and where best to get one from?

  4. #4
    Quote Originally Posted by redeye83
    Where abouts is it and where best to get one from?
    Inside the dash, they're readily available from most auto factors & iirc cliolord made a guide on how to do it

  5. #5
    Moderator
    Join Date
    Sep 2004
    Location
    Hinckley, Leics.
    Posts
    7,816
    Try flushing the cooling system first.

  6. #6
    Forum User redeye83's Avatar
    Join Date
    Dec 2008
    Location
    worcester
    Posts
    294
    I've not long done a top end rebuild and have flushed the system. You got a spare one at all mat?

  7. #7
    Moderator
    Join Date
    Sep 2004
    Location
    Hinckley, Leics.
    Posts
    7,816
    They are only about £30 new so not worth using a 2nd hand one.

  8. #8
    Forum User
    Join Date
    Jan 2007
    Location
    Wilts
    Posts
    274
    You don't need to remove the dash to fit them too, you can slide it forward just enough to slide the matrix out from the passenger footwell side

  9. #9
    Forum User
    Join Date
    Jan 2012
    Location
    Abbeyfeale, Limerick, Ireland
    Posts
    192
    Quote Originally Posted by 16v_russ
    You don't need to remove the dash to fit them too, you can slide it forward just enough to slide the matrix out from the passenger footwell side
    You sneaky bastard!!!

  10. #10
    Couple of things..if the thermostat is buggered would it not effect heating in the cabin? have you replaced it?

    The other, try sticking a pressure washer hose into the matrix from the bulkhead. This will certainly clear out any blockage in the matrix. Leave it run for 10 minutes each pipe and make sure you allow the system to bleed correctly thereafter.
    If the matrix is not leaking in the cabin can't see why you would want to go through the hassle of replacing it.


 

Similar Threads

  1. heaters and rad fan =/
    By webby in forum Mechanical
    Replies: 4
    Last Post: 22-03-2009, 20:28

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •