Camber

[Vandella]

apart from the parts..what would u need me to have.. tools/stands etc?

[Vandella]

evogone has a wide track setup.. that be a good choice?

[MatBrown]

This track rod/tie rod looks wrong. The rod end is almost completely wound in, not sure if that's right? I use different ones so it's hard for me to say.

Probably cos they have tried to wind a williams rack into 16v width.

[fabulicious]

For your shocks check if there is a little white paint mark on them. Williams ones do. That number you have there does not correspond to anything on my receipt so not sure what its from. Some 19 no doubht.

[Minichapperz]

*hijack

wobba where did you get that tool from for the track rods, i can do with one of them for work :P

[Wobba]

This track rod/tie rod looks wrong. The rod end is almost completely wound in, not sure if that's right? I use different ones so it's hard for me to say.

Probably cos they have tried to wind a williams rack into 16v width.

Yea maybe.

Fab, I checked diaologys for the shocks and the part is the same as Williams strut part number.

Cant remember where I got the tool from, I probably linked it here somewhere in the past.

[fabulicious]

sorry wobba meant to say springs the shock number is correct.

[chip]

Get a set of R19 arms, you can get them for under 40 quid a pair if you shop around, they give more castor as well as the extra track, so area better than the williams verison IMHO

[Vandella]

is there any way of telling if i have valver driveshafts? is there a difference in diameter of any of it? i was thinking..if i have willy driveshafts and valver wishbones and arb. would this not be squashing to an effect the driveshafts? and as i have adjustable camber bolts sqeezing as much as poss out of them that its making this problem/scenario worse? or not doing it much good....?

[MatBrown]

Main way of telling the difference is the length.