Hello guys,
I've just installed an adjustable bias valve instead of the factory load proportioning bias valve and now need to bleed the rear.
I tried to bleed the rear but the pedal just went hard and could not bleed the rear. I understand this has happened because the front is already bled, therefore the master cylinder has no where to push. I know the system should be bled as a whole, following a certain sequence, but is there any way of bleeding just the rear ?
I did not start the engine because I had the tank removed and currently have no fuel. Will it make any difference if I start the engine ?
Ohhh and bdw, the car is a Renault 5 GTT, I presume everything is the same as the clio (at least everything looks identical to my 16v).
Any help is greatly appreciated.
Cheers,
David.