16v 449 Blue rebuilt f7p j reg

[midge]

all parts available
recuilt f7p with kent rn1601 cams 50k miles on the engine, all reciepts for rebuild from bb tuning, can be driven as its still in the car

[midge]

breaking a 449 16v
engine - 50,000 miles, has had rebuild with reciept to prove, kent cams fitted, ported head, re-mapped ecu, have all the reciepts to prove this
will come exactly as its lifted out (except the loom) so will be ready to go into another car, or even a 16v conversion
£450

mint jb3 valver gearbox £70
hubs with new bearings £30 each
valver suspension lowered 40mm £50.

body -
front wings very good condition £30 pair
front bumper few chips £20
rear bumper few marks £20
phase 1 grill £10
smooth doors, bit off damage on one £30 pair
side skirts £20
spoiler £20
side reps £6
full set of tinted glass with non opening rears £30
smooth boot with popper installed £30

interior -
ph1 dials and oil dials £30
top dash £5
sterring wheel £20
massive rpm gauge £10
black carpet £10
black center consul £5
ph1 interior, drivers seat ripped £20

other -
magnex back box with standard center section £50
cat £30
single wiper conversion £30
headlights £5 each
ph1 rear lights £15 pair
5 spoke alloys with good 195 45 15 tyres £50

anything else just ask.
keep an eye on my ebay for lots off clio stuff going up for sale (new stuff going up daily!)
http://search.ebay.co.uk/_W0QQsassZ52egdimQQhtZ-1

[Wobba]

Do you mean stub axle and front bearings £30?

How 'new' are the new bearings?

[canelloni]

Hi pal how much for strut brace ? And I'm after the little brackets that hold the trim on between the bonnet and bumper if they same as Williams 3

[midge]

bearings are 2 months old, no play at all

the strut brace is spoken for, and the grill clips are diffrent im afraid

[Goglerom]

valver suspension lowered 40mm £50

still got these mate?

[midge]

all gone