help!!!!!!!!!!!! please

[pieman]

right to start i am mechanic so i hope i haven't done somthing wrong which makes me look like a tit!!
right brake compensating valve at the back just got a new
1 as the foot brake was poor and never cleaned the disc up
never mind a shite hand brake!!
simple remove refit job! but now i cant bleed the n/s/r brake,
there are 4 pipes which go in the valve 2 from the front and
2 which goes to the flexies and then on 2 the back! i have fluid
goin in the valve from the the 2 front pipes and only coming out
of 1 at the back! (eh u say) i can take the pipe from the n/s/r
of the valve completly and have a pedal this just does not
make sence! i can undo 1 of the other 3 and the pedal sinks and
fluid goes every where like it should! what is goin on?????
i no the new valve is not blocked as i have blowen through it with
my air gun and i can feel preasure coming out the other side IT JUST DOES NOT MAKE SENCE!!!
i hope i have been clear and u under stand what
i'm ranting about

[VIPERONE]

sack off the valve in favour of an incar bias adjusting lever

[Chris H]

do you have the valve fully shut?

[pieman]

i've had it open, shut, half way lol

[Chris H]

well if its fine on the lines to the bias valve then not after it its got to be an issue int he valve despite what your airgun test said.