put a f7r engine and gear box from a megane in the clio with the clio head. had alot of work done on it kent cams flowed and ported. so thinking of getting throttle bodys to finish it off. can enyone tell me the best kit to get
put a f7r engine and gear box from a megane in the clio with the clio head. had alot of work done on it kent cams flowed and ported. so thinking of getting throttle bodys to finish it off. can enyone tell me the best kit to get
depends mate
if you want it all done for you cant go far wrong in contacting stan @ APD
http://www.ap-developments.com/
best off savin urself a lotta quid n DIY tbh. get the mapping done by someone with a r/r set up ....roberts ur mums bro.
jenveys are dear, webers do the job just as well and at a fraction of the cost. bike bodies can be had even cheaper, but are a little too small omho.
what weber throttle bodies are good for the williams. do you have experience of running the weber units and what improvements in terms of performance do you get and how does this compare to jenvey units. i'm also guessing a standalone ecu is required
yes i ran my williams on webers. complete kit. weber alpha ecu is supplied with the kit. was £1700 for the kit, loom, mani, bodies, ecu etc.
i got the kit off another car, but it was mapped badly, and i never got round to getting it mapped correctly either. performance wise....made a shit load of diff. had quite a few do's with my mates ra spec scoob, and he couldnt get anywhere near me. neither could any of the others i had a play with. only car i had probs with was jesus' 172 but then, with a decent mapping sesion, i reckon that would have been same story.
how it compares to jenveys i dont know, the bodies were fitted to the same engine that i raced the white bodied beast with, in std inlet i lost about 1/2 car to a car legnth per gear, with the bodies on, i reckon id have pulled on it.
gunner had a quick ride in it, whilst we were comparing over the moors against his vx. it also came about that we had a little play with a scoob on that run too.....hehe.
was the complete kit specific for the williams
ta for that, food for thought as they say
http://www.williamsclio.co.uk/forum/...ic.php?t=37054
worth a look. The jenvey bodies are definitely better than the weber ones