Hub nut issue, urgent

[kenny]

Hope this post is too late, or you are still struggling. Jam nut tight with nail or similar. Use angle grinder and cutting disc to remove whole arc of nut. Ok if you don't need to worry about splines.

[schakal]

easy now suckers !!!!

not my fault i did not get your pikey chav speak

borrow the dremel from lainer and cut the hubnut out from to sides
than smash it with hammer ,watch for 2 halves come apart
job done

[summeh]

i have a dremel if u need to borrow it mate, have cutting stones and discs.... let me know, would take about 5mins with it.

[Wobba]

i have a dremel if u need to borrow it mate, have cutting stones and discs.... let me know, would take about 5mins with it.

awesome! cant drive though :(

[Wobba]

Its taking hours as my drill keeps running low of batteries and I've broken 3 drill bits and the other ones suck.

[Rob72]

if the thread is stripped,get a socket the same diameter of the shaft thread..
then get a big hammer n whack it hard , then unscrew.
do this over n over again.

[LEIGH-ANNE]

did u sort this dan?

[schakal]

Yeah cmon schaksckalah, everyone knew what he meant, stop being a faggot.

thats rich coming from a bum chum that pesters
chinese OAP`s in night clubs for anal sex


:D

[x_tara121_x]

jeez guys on here are so bitchy to each other, just useful comments would probably be helpful. im guessing with all this advise you have it sorted by now. i'd personally have gone for the cutting option. cant be assed with piss assing about with things like that. anyhow hope its sorted... we still have our problems but as long as another is done

[MatBrown]

Wobba - Officially the unluckiest home mechanic!


Mat.