this is rear mate :D
Originally Posted by MAXIBOY
I have been quoted £150 plus vat ,each for these any diameter.I will have to take one of my spares as a sample for the splines,exact length etc etc.
Anyone wanting further info,please get in touch.
When you consider,about 5 years ago I got hold of a brand new REAR anti roll bar ( Grp "A" book) through my Renault agents ~~ It cost me £140 plus vat then Just for the bar,I then had to make the mountings etc etc.
Rod
lose the torsion bar and go full coilovers, pretty sure kits are available to do this
What diam do you run Rod ?Originally Posted by cliorod
Alot of class regs dont allow this.Originally Posted by TheJesus
Mine dont: "original suspension type must be retained".
Steve,What diam do you run Rod ?
To be honest,I have not checked .It uses a proper Gp "A" ish beam ~~ from the Irish car.I thought if those lads have got it set up for the Irish lanes,it will be ok for Mull and the like.I will check for you,next time I put in on axle stands etc.
please do mate..
i assume 23.2mm but may be 24.5mm..
get it on stands soon..
Good Evening All, sorry to bring up an old thread, but what are the lengths of these bars and how many splines at each end? I'm actually researching for an R5 GT Turbo, but as alluded to above, fitment is the same.
Woz
I've currently got my GTT Rear Beam off the car and have modded it to accept 172 stub axles and brake caliper mounts. I also removed the torsion bars and I'm now looking for upgrade options noting all of the above. I've taken the length measurements, that will be the same as the Clio 16V/Williams and got:
Torsion Bar - 595mm
Anti-Roll Bar - 507mm
If anyone has anything drastically different I'll be surprised. I'll post again in 2022!