You know when you go round a corner at slowish speeds, ok? You can usually tickle the accelerator and the car self centres itself and you dont need to give much assistance on the steering wheel for this to happen, right?
Well:
Had some outer ARB polybushes the other day which I fitted and set to half what they suggest on the torquing up as it seemed plenty and there was no sign of it going anywhere near the 20 lb/ft torque on the wrench...
I noticed it was a little reluctant to self centre.
Today I tightened the nuts holding the ARB's on to see what it was like round corners afterwards. It's definitely flatter on turn in and more direct, but you have to wrnech the wheel round back to centre or else it will just keep turning itself!
Is this normal and is there a way to dial it out using other methods?