Dropped the subframe some-what to change the rack, took out 3 bolts but left the front drivers side bolt in.
I've jacked the subframe up to the correct level but the holes don't line up??? Am I missing something or is the frame bent :S
Dropped the subframe some-what to change the rack, took out 3 bolts but left the front drivers side bolt in.
I've jacked the subframe up to the correct level but the holes don't line up??? Am I missing something or is the frame bent :S
Check the radiator is seated properly.
Pretty sure its seated right will have to check but it was seated right when i lowered the subframe, had this problem when I changed the box as well, took 2 of us to do it, 1 to push the subframe as hard as they could and 1 to try and push the bolts in!
loosen rhw 4th bolt, and then re-align.
Hmm yeah have to have a look I think it might be bit loose thou, I tried taking it off before and it just spun so :S
the bolt closest to the bulkhead? you'll need a spanner on top of it to prevent it spinning i think
Yeah loosened the other bolt and it lines up much easier now hehe
school boy.. :P
shouldnt tighten anything up till there all in, goes for pretty much everything you do IMO