evil, just done mine and it snapped again. make sure u get a genuine renault replacement that was my mistake and when u remove the old one note the routing, particularly round exhaust downpipe!
easy in terms of putting cable in, whip off battery, airbox and exhaust heat shield then unclip from gearbox end and feed out. unhook for pedal end (or if its snapped just pull!
refit by routing cable from pedal end first, difficult bit this as you have to go up and through the pedal housing n hole is really small! i used a bit of wire to pull it through!
then feed through the locating loop and up the back of the clutch pedal over auto-adjuster ensuring sits into groove correctly, then push up the clip that holds cable on pedal(spring loaded) and hook the end of cable in. i removed bottom trim panel to help me see! then route the cable behind zorst and clip to subframe routing points, up and over gearbox and round to the mounting. loop through and hook onto release lever on gearbox. the push pedal but be careful cuz if the cables too short it'll pop straight out the pedal mounting hook and get stuck (well annoying) if shud put up usual stiif valver resistance straight away then ratchet itself on the auto adjuster.