Quick question about lowering a torsion bar

[NaplesValver]

Ive got this guide printed out:

http://www.zedsplace.co.uk/e107_plug....php?content.9

but would like to know what size socket, bolt and nut i use to make the tool???

cheers

-->NV

[donsrno1]

bolt and nut are M10 and socet is 32mm IIRC. Probably best to wait for these to be confirmed though. You can use a few different sized sockets but I think 32mm is OK.

[jwarren2k2]

yeah thats right^^^

M10 thread with 32mm socket! :D

[NaplesValver]

Cheers guys, just what i was after.


just need the valver now

Also, what drive does the socket need to be, or does it not matter??

-->NV

[donsrno1]

the drive won't matter as long as theres enough room to get the bolt through. I would think most 32mm ones will be 1/2 inch anyway. I've never checked if there would be enough room in a 3/8 drive socket for the nut.

[Lunner]

only just fits in a 1/2drive socket, as above, never seen a 3/8" drive 32mm socket