Search:

thinking of getting some clio williams seats for my five how much should i be looking to pay for a nice set front and rear?

im using the original mounts but as the clio has that extra mount there i think might as well use that as well can hurt having a extra mount makes it look a bit more factory too i thinks anyways....

i need both parts of the engine mount that bolts to the cambelt cover? its for my r5 f7p conversion so may have to adapt it not sure how it will fit exactly so dont want to spend out to much.
...

thanks hopefully i have got one one the way now.

plastic and the bolts for it

hello im after a cambelt cover for a mk1 wiliams clio. if anyones got one drop me a message please

well i have ordered it off 519 i am getting the injection model that is basically just running the ignition only software so later on if i run throttle bodies i don't have to swap ecus just update...

well i have emailed 519 just waiting for them to get back to me hopefully will buy it through them and when its got a base map it runs okish ill run it down there. well thats the plan anyways

i looked at megasquirt but wouldnt no where to begin on ordering it sounds so confusing

i tried calling him a few times but no answer so will pop him over a email i would go get it fitted but i kinda want to do it my self in some respects doing the car is as much fun as it will be...

i spoke direct to canems but they where helpfull may speak to 519 automotive aswell. not running wasted spark not to fussed about that but the bloke at canems said i will have to swap out the...

thanks this is a great help called them today they really was so helpful and i think this is the route i am going to go down, just wanted to know from you what you think of the ecu and the company as...

sorry should of added its on a renault 5 an the engine is a tight fit so dont fancy taking it back out to change the flywheel. canems havent heard of it is it good?.

i may change the flywheel at a...

no one fitted a trigger wheel to a f7p ?????

hello

just wondered if any of you lot with f7p lumps are running nodiz or efi if so what trigger wheel did you use and what did you do about mounting the sensor for it? is there a complete kit...

need a phase 1 (91-98) possibly i believe just engine loom its going into my renault 5 as my loom i am using has been chopped around a bit. this sites been great for parts so far so hopefully someone...

does anyone have a wiring loom diagram for the engine loom of a mk1 1.8 16v. got some wire on my loom that go now where and it dont run. of most interest is the wires that go in the coil pack.

hello in need of a 1.8 16v clio loom and ecu got to be working pm me.

i am located by bluewater shopping centre

need a working f7p starter motor ideally close so i can pick it up tomorow or special courier delivery and i will pay.



Thanks

Ryan smith

need some new or old just need them asap

need f7p flywheel bolts cant seem to get them anywhere can anyone help with a part number or any ideas where i can get some dont need to be new but need them asap

basically after a f7p engine good running order for my r5 project. can travel and collect

Pm me

Thanks

Ryan