-
Engine Parts for Rebuild
Hi all..
thread is as per title really , im going to be looking at starting to stock up on parts for a rebuild.. as much OE as possible.. thing is, there'll be loads of bits that ill miss or be unaware of..
if someone has a few mins could you list everything that would ideally need changing/replacing within the engine..
so literally anything you can think of.. seal, gaskets, guides, springs, tappets, pistons, valves, sensors, pumps etc and ill build a list up..
thanks for your time in advance peeps
-
Don't waste your time, just give the engine to whoever is gonna build it & let them get the parts as the parts you need will depend entirely on what measurements are taken from the crank & the bores.
You could end up buying everything & find that it's all useless because they're the wrong sizes.
You do however want to buy this part now as it's easily overlooked http://www.ebay.co.uk/itm/1407042182...%3AMEBIDX%3AIT
-
fair enough mate, ill do just that.. As for the oil pump bit u link too, was this what you mentioned to Crossers about his possible ticking?
what do those bits do out of curiosity?
-
It is. It's a bearing for the oil pump drive, works in the same way as the shells & bearings on the crank, oil is pumped into it at high pressure to allow the shaft that drives the pump to spin