-
williams wider track
HI all,
i got a 16v with williams engine a few months ago and was told it had as wider track on the front. after investigating this and messuring with a williams i can see it isnt but what i can see is that its the wishbones that are wider and not the actual sub frame. iv looked at a parts list for drive shafts and they seem to be the same code as the 16v ??? iv not looked at anything else but i assume the roll bar and track rod ends must be longer ???
am i correct ???
cheers ST :wink:
-
widetrack consists of
wider and thicker ARB with different outer mounts
longer wishbones
longer driveshafts
different front struts
longer front brake flexi lines
thats it
subframe is dimensionally the same, just triple skinned on the williams
-
technically track rods are longer aswell i think, but usually enough give in the valver track rods and ends to wind them out to compensate safely
-
post a picture up . can tell in seconds
-
post a picture up . can tell in seconds
-
how can you tell the differance ??? i will tomorrow but its dark and dont think it will work.
-
easiest spot is valver runs a noticable amount of camber, and the williams doesn't !
-
ye this seems to be like that but he said he put a williams sub frame on it so maybe he did but didnt put any of the other stuff on it ???
-
quite possible as you wouldnt notice any difference with just the subframe
-
the silly bugger. how much does it cost to make it into the wider track ???