Printable View
Okay i've got a OMP strut brace and held it against the motor.
Looks like its to short or my struts are bent. Seems to be a gap (not sure on the mm) is this right? thought it would "kind of" wedge in.
Its a soild bar.
I'll get a pic or something tomorrow.
Cheers
need pics...but should be a tight fit..
I've seen some where there is a bit of a gap, not a lot mind. Dont forget, its sposed to stop flex outwards, as well as inwards.
Okay just tried it in place again and its a decent fit.
I think the reason it had a gap was because i tried it in place without the ignition module. which would add about 2mm, and the engine was out which could (at a guess) cause the struts to maybe flex out a bit.
Thanks any way and sorry for wasting your time.
(Off to stand in the corner for a bit)