View Full Version : changing exhaust manifold *gasket*, how hard?
simpe as just removing them bolts bolting manifold to engine block/head and sliding the exhaust back a bit?
undo the 10mm nuts holding it to cyl head and undo the mount lower down to the engine so it allows u to slide it back
VIPERONE
28-03-2006, 23:30
use a ratchet 10mm spanner, undo all nuts remove downpipe and then just pull off studs, noting which side the metallic facenof the gasket goes :-)
As above.
Just do bolts up evenly.
pray none of them are seized.
When I put my supersprint on luckily all of them come off just fine.
Was certain they'd all be seized though. :lol:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.