View Full Version : 16v / Williams body panels
been looking at www.sel-imperial.co.uk
and looking through the panel list I looked at the rear arch ones
www.sel-imperial.co.uk/partimages/2166L.jpg
www.sel-imperial.co.uk/partimages/2166R.jpg
could these be used for the 16v and Williams as were ours flair out those one stop etc ??
that picture looks like a non williams / valver wing mate
It will fit but they wont look all that good.
clowo16v
22-02-2006, 13:15
Go to your local auto factors they'll be able to get you the correct one for about £25-30 a side.
See ya
Matt
So they can still be got hold of then.
When I spoke to a couple of body shops they said all I could do was cut out the rust a patch it back up as they didnt make replacment arches for the 16v / Williams
Excuse my complete ignorance, but what's the difference?
="neilc"]So they can still be got hold of then.
When I spoke to a couple of body shops they said all I could do was cut out the rust a patch it back up as they didnt make replacment arches for the 16v / Williams
Still available from Renault, I bought one just before christmas.
James Clio 16v
22-02-2006, 14:16
="neilc"]So they can still be got hold of then.
When I spoke to a couple of body shops they said all I could do was cut out the rust a patch it back up as they didnt make replacment arches for the 16v / Williams
Still available from Renault, I bought one just before christmas.
How much was it mate?
Cheers
James
Just a few £ short of £400 IIRC but I got it a bit cheaper as I bought a door as well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.