jimflin
11-02-2006, 20:21
Hi there everyone...
I recently installed a new heater matrix on my clio 16v.. everything went back together fine, howver since then if i go over 5000revs the idle wont go back to 1000 but insists upon sitting at 1500...
I also put a new spedo cable on there but i didnt connect anything to the connecter near the end the plugs into the back of the instument panel.. I didnt see anything around I dug arond the back for a while but then came to the conclusion that there was not one on there previously... I can't remember unplugging anything first place i was rushing at the time...
Can anyone tell me if this is infact the case. Do i just have to have a better look or is it infact something more serious and that connector is not used on the 16v models?
Cheers for your help.
I recently installed a new heater matrix on my clio 16v.. everything went back together fine, howver since then if i go over 5000revs the idle wont go back to 1000 but insists upon sitting at 1500...
I also put a new spedo cable on there but i didnt connect anything to the connecter near the end the plugs into the back of the instument panel.. I didnt see anything around I dug arond the back for a while but then came to the conclusion that there was not one on there previously... I can't remember unplugging anything first place i was rushing at the time...
Can anyone tell me if this is infact the case. Do i just have to have a better look or is it infact something more serious and that connector is not used on the 16v models?
Cheers for your help.