View Full Version : 16v exhaust on a williams
hi, just a quick question really. does anyoone know if an exhaust off a 16v would fit a williams ok?
Thanks
Harry
It will be fine if you are still using the Williams CAT or a Williams De-CAT iirc
clowo16v
04-02-2006, 16:02
I think you need to use the Valver cat/de-cat as on the Williams the flanges are in the same plane, wheras on the Valver they're 90 degrees apart.
See ya
Matt
Justin..
04-02-2006, 19:00
16v exhaust will be fine at the cat/decat
MatBrown
04-02-2006, 21:00
The hanger might be different on the U bend.
Mat.
The hanger might be different on the U bend.
Mat.
i love renault, totally pointless redesigns!!
VIPERONE
05-02-2006, 01:20
no.
Hi,
I replaced the cat-back part of the exhaust on my Williams 1 last week.
I ended up putting a genuine Renault one on it.
I ordered a Bosal replacement first (cheaper). Both Bosal and Timax swore the 16v model would fit OK (they no longer list a Williams model).
The garage (Steadfast in Wokingham) tried to fit it and found two problems: the length of the centre silencer section connecting forwards to the cat was too short and the section passing over the axle needed a pinch in it because the Williams is lower than a 16v and "it would cause banging".
The centre silencer section was £70.96 + VAT
The rear silencer section was £159.92 + VAT
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.