View Full Version : lowered the mofo
lowered the 16v yesterday, went a bit too far, and had to up it slightly lol!
Before:
http://homepages.nildram.co.uk/~cadams/images/lowering/before.jpg
After:
http://homepages.nildram.co.uk/~cadams/images/lowering/loooow.jpg
After again:
http://homepages.nildram.co.uk/~cadams/images/lowering/low.jpg
Justin..
02-10-2005, 12:13
cool, never seen a white valver before. looks the nuts good job
That looks lovely.
1st attempt was certainly a bit low.
Andyvalver
02-10-2005, 15:41
:P Nice
Looking good craig, can you send me a step by step guide on how to do it fella, please, as im gonna take mine up next weekend I think?
like it craig..mine needs doing big time lol
danny no probs, we made a guide when my mate first did mine on the nana!
http://homepage.ntlworld.com/brian.morris5/zclio/Torsion_Bar_Guide/guide.htm
lewis_willy2
02-10-2005, 17:16
how many spline do u need to go round?
what does 1 spline = __mm
2 splines= __mm
not sure mate, we just jacked it up how much we wanted to lower it by, then played around slightly untill the torsion bar went back in properly...
Where do you put your stand at the back craig?
Excellent guide, you make it look easy
What size socket and bolt thread do you use ??
Might have to talk my mate into having ago at mine.
Justin..
02-10-2005, 21:18
i see the trusty old halfords jack and stands :wink:
Excellent guide, you make it look easy
What size socket and bolt thread do you use ??
Might have to talk my mate into having ago at mine.
I used a 38mm Socket and a M10 Bolt with 2 nuts and a washer.
were does the second nut a washer go ??
All I can make out is thread, nut, socket in that order.
my m8 lowerd his the other week....dropd it right on its ass! luks quality allthough i dont think he can go over speed bumps....or any type of bumps 4 that matter :?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.